Use this calculator come estimate just how much sand in volume (cubic ft, cubic yards, or cubic meters) or load (tons & pounds, tonnes and also kilograms) you would need. It uses conventional sand density.

You are watching: 1 cubic yard of sand weight


Calculating just how much sand friend need

Many builders and gardeners are challenged with calculating or estimating the lot of sand they should fill a given an are with sand. Ours sand calculator is of good utility in together cases, yet you should keep in mind that the outcomes will only be as good as the dimensions entered. The calculation procedure is together follows:

Estimate the volume the sand needed, making use of geometrical formulas and plans or measurements.The approximate thickness of sand is 1600 kg/m3 (100 lb/ft3).Multiply the volume through the density (in the same units) to gain the weight

There is finer and more coarse sand, so the density, measured for dry sand in kg per cubic meter or pounds every cubic feet, that your specific shipment might vary. For this reason, and due come potential loses / waste, girlfriend should think about buying 5-6% much more sand than estimated so girlfriend don\"t operation just short of what you need in the end.

Square or rectangle-shaped area

The volume formula for a rectangle-shaped (or square) box in cubic feet is height(ft) x width(ft) x length(ft), as viewed in the number below:

\"*\"

For example, to fill a box with a broad of 3ft and also a length of 6ft, to a depth of 1ft, you should multiply 1ft x 3ft x 6ft = 18ft3 (cubic feet) of sand.

Round area

If the area you desire to cover, or the form you want to to fill is round, the calculate is a little different:

\"*\"

The volume the a number with a round foundation is its height times the area the its foundation. To calculation the foundation area we require its diameter, due to the fact that the formula is π x r2, where r is the radius, or diameter/2.

Irregularly shame area

In case the area you room calculating has an irregular form what you desire to do is divide it in several regularly-shaped sections, calculate your volume and also sand requirements and also then amount them increase together. In case you finish up needing to perform this because that a big number that sections, you might use ours summation calculator.


Sand basics

Sand is a naturally occurring granular material which is created of finely divided rock and also mineral particles, rounded and polished come a differing extent. Sand can be believed of together finer gravel, or coarser silt. In part cases, \"sand\" refers to a textural class of soil, that is - a floor which has more than 85% that its mass consisted of of sand-sized particles. Sand is a renewable source in the lengthy run, yet in person timescale that is practically non-renewable. Sand is a significant component that concrete and also due come the high demand for concrete for construction, perfect for concrete sand is likewise in high demand.

The most usual constituent that sand in inland continental settings and non-tropical coastal settings is silica quartz (silicon dioxide - SiO2). The 2nd most common kind of sand, mostly encountered in islands and also near the sea, is calcium lead carbonate which is developed by various life-forms, choose coral and also shellfish. The course, the specific composition will certainly vary depending on local rock sources and also conditions during the formation of the pebbles.

\"*\"

Sand for residential or garden usage is usually offered in tiny packets of several pounds / kilograms, and also for larger projects in bags the 40, 60 or 80 lbs - 25kg or 50kg in Europe and other places. For construction work, concrete mixing, etc. The is marketed by the tonne and also comes in trucks.

species and qualities of sand

Contrary to what you might think, over there is more than one kind of sand, through the size of the pebbles and it\"s intended usage <2>. Choosing the right type and dimension is crucial, as part sands have actually a various application 보다 others.

Sand typesTypeDescription
20-30 Sandn-standard sand, graded to happen a 850μm sieve and be kept on a 600μm sieve.
Graded Sandn-standard sand, graded in between the 600μm sieve and also the 150μm sieve.
Standard Sandn-silica sand, composed almost entirely of normally rounded grains of practically pure quartz (used for mortars and testing of hydraulic cements).

Standard sand, in addition, chandelier be light grey or whitish color, must be complimentary from silt and also the grains must be angular, however a little percentage the flaky or rounded particles room permissible. Some manufacturers to express the class and type of the sand in various other ways, e.g. \"river sand\" (a.k.a. \"sharp sand\", \"builder\"s sand\", \"grit sand\", \"concrete sand\"), \"masonry sand\", \"M-10 sand\" (granite sand), \"play sand\", each being finer and more expensive 보다 the ahead one.

What is the thickness of sand?

The density of typical sand is 100 lb/ft3 (1600 kg/m3). This synchronizes to moderately damp sand and also is the number offered in the calculator.

How much does a yard3 that sand weigh?

A cubic yard of usual sand weighs around 2700 pounds or 1.35 tons. A square yard the a sandbox through a depth of 1 foot (30.48 cm) weighs about 900 pounds (410 kg) or slightly much less than half a ton. The water contents of the sand is presume to it is in moderate.

How lot does a cubic meter of sand weigh?

A cubic meter of usual sand weighs 1,600 kilograms 1.6 tonnes. A square meter sandbox with a depth the 35 cm weighs about 560 kg or 0.56 tonnes. The numbers are acquired using this sand calculator.

How lot is a ton that sand?

A ton of sand is typically around 0.750 cubic yards (3/4 cu yd), or 20 cubic feet. Sand is assumed fairly damp, since adding water can increase or to decrease the thickness of the sand considerably (e.g. If it was raining or if you dig up and leave sand under the sunlight so water evaporates).

How lot is a tonne that sand?

A tonne of moderately damp sand generally fills around 0.625 m3 (cubic meters). It deserve to be much more or less dense depending top top water content and also the size of the sand particles.

Ton vs tonne, loads vs tonnes

When calculating the sand\"s weight, make sure you do not confused the tonne (metric ton) v the ton (short ton). The first one is offered by all countries in the world and also is identified to be same to 1000 kg by the global body that standardization. The ton is currently only provided in the unified States and also is equal to 2000 pounds (2000 lbs). The difference between the 2 is not substantial but deserve to quickly add up to a far-reaching number together the quantity increases.

See more: How Many Kilometers Are In 5 Meters To Kilometers, Kilometers To Meters (Km To M) Converter


References

<1> Krinsley D.H., Smalley I.J. (1972) \"Sand\", American Scientist 60:286-291

<2> ASTM C-778 - 17 \"Standard Specification for traditional Sand\"


Cite this calculator & page

If you\"d prefer to mention this online calculator resource and info as detailed on the page, you deserve to use the adhering to citation: Georgiev G.Z., \"Sand Calculator\", obtainable at: https://www.lifwynnfoundation.org/calculators/sand-calculator.php URL .